+49 (0) 8631-3766-0
 
 

BPS-Twin-13.0-RSE

SVP410116

for cars and trucks until 13 t axle load

Information request

"BPS-Twin-RSE" scope of supply:
- 2 roller sets, hot-dip galvanised, for installation in an inspection pit, suspended installation, welded roller profile,
20 m pre-wiring to the control box
- Control box with motor protection switch, control electronics, operating elements and main switch lockable, prepared for
connection of side slip and axle suspension, water jet-proof IP 65
- TÜV-tested and approved for § 29 inspection

Description of "BPS-Twin" roller set:
- 2 split roller sets, hot-dip galvanised, suspended installation with watertight, maintenance-free roller bearings
- Standard raised roller by 40 mm on the access side, exit side at ground level. The raised roller is implemented through
shimming with compensation plates beneath the bearing blocks. This allows ground-level or raised positioning of the rollers
at any time
- Drive motors with planetary gears, enormous motor power with minimal power connection values,
- Test unit control: Manual / automatic operation, delayed automatic switch-on, slip switch-off, pointer stop, automatic
restart, switch-off after driving out of the test bed, start-up monitoring and drive-off assistance
- Wear-free, electronic DMS measuring system with shear force transducer

Technical data for roller set "BPS-Twin 13.0 (13. 8)”:
- split roller set, hot-dip galvanised: Motors below the rollers
- Dimensions per roller set W x L x H: 1,220 x 1,045 x 545 mm
- Weight per roller set: approx. 420 kg
- Roller length: 1,000 mm
- Roller diameter: 205 mm
- Roller profile, welded: Friction value dry / wet 0.9/0.8
- Slip roller diameter: 50 mm
- Roller centre distance: 420 mm
- Test speed: Planetary gear with 2.6 km/h
- Noise emissions LWA: <70 DB (A)
- Traversable axle load: 13 (18) t
Testable axle load at 50% braking:12 (15) t
- Maximum braking power: 32 (36) kN
- Nominal power of drive motors: 2 x 7.5 (9.0) kW
- Supply voltage: 3 x 400 /50 V / Hz
- Feed line/fuse protection: 5 x 6 / 32 mm² / A
- Measuring system, shear force transducer with: integrated measuring amplifier DMS

Technical data for roller set "BPS-Twin 18.0 t", deviating to 13.0 t:
- Weight per roller set: 460 kg
- Roller diameter: 268 mm
- Roller centre distance: 440 mm
- Traversable axle load: 18 t
- Testable axle load at 50% braking: 14 t
- Maximum braking power: 34 kN
- Nominal power of drive motors: 9 kW