+49 (0) 8636 / 60998 00

BPS-Twin-13.0 (low-loader version)

SVP410116 & SVZ410044

for cars and trucks until 13 t axle load (low-loader version, split type)

Information request

"BPS-Twin-RSE" scope of supply
- 2 roller sets, hot-dip galvanised, for installation in an inspection pit, suspended installation, welded roller profile,
20 m pre-wiring to the control box
- Control box with motor protection switch, control electronics, operating elements and main switch lockable, prepared for
connection of side slip and axle suspension, water jet-proof IP 65
- TÜV-tested and approved for § 29 inspection

Description of "BPS-Twin" roller set:
- 2 split roller sets, hot-dip galvanised, suspended installation with watertight, maintenance-free roller bearings
- Standard raised roller by 40 mm on the access side, exit side at ground level. The raised roller is implemented through
shimming with compensation plates beneath the bearing blocks. This allows ground-level or raised positioning of the rollers
at any time
- Drive motors with planetary gears, enormous motor power with minimal power connection values,
- Low-wear running rollers with welded profile surface (optionally grit-coated)
- Test unit control: Manual / automatic operation, delayed automatic switch-on, slip switch-off, pointer stop, automatic
restart, switch-off after driving out of the test bed, start-up monitoring and drive-off assistance
- Wear-free, electronic DMS measuring system with shear force transducer

In addition:

Roller set "RS-1.50" for BPS-Twin-13.0 (low-loader version)
Hot-dip galvanised, roller length 1.5 m

Technical data for roller set "BPS-Twin 13.0:
- split roller set, hot-dip galvanised Motors below the rollers
- Dimensions per roller set W x L x H 1,220 x 1,045 x 545 mm
- Weight per roller set approx. 420 kg
- Roller length 1,000 mm
- Roller diameter 205 mm
- Roller profile, welded Friction value dry / wet 0.9/0.8
- Slip roller diameter 50 mm
- Roller centre distance 420 mm
- Test speed Planetary gear with 2.6 km/h
- Noise emissions LWA <70 DB (A)
- Traversable axle load 13 (18) t
Testable axle load at 50% braking 12 (15) t
- Maximum braking power 32 (36) kN
- Nominal power of drive motors 2 x 7.5 (9.0) kW
- Supply voltage 3 x 400 /50 V / Hz
- Feed line/fuse protection 5 x 6 / 32 mm² / A
- Measuring system, shear force transducer with integrated measuring amplifier DMS

Roller set "RS-1.50" for BPS-Twin-13.0 (low-loader version)
Hot-dip galvanised, roller length 1.5 m