+49 (0) 8636 / 60998 00
 
 

BPS-Twin-18.7 Traktor

SVP410137 & SVZ410009

for tractors, trucks and cars until 18 t axle load, testable wheel size until 48" (split type)

Information request

"BPS-Twin-RSE" scope of supply
- 2 roller sets, hot-dip galvanised, for installation in an inspection pit, suspended installation, welded roller profile, 20 m pre-wiring to the electrical/control box
- Control box with motor protection switch, control electronics, operating elements and main switch lockable, prepared for the connection of side slip and axle suspension tester,
water jet-proof IP 65
- TÜV-tested and approved for § 29 inspection

Description of "BPS-Twin" roller set:
- 2 split roller sets, hot-dip galvanised, suspended installation with watertight, maintenance-free roller bearings
- Standard raised roller by 40 mm on the access side, exit side at ground level. The raised roller is implemented through shimming with compensation plates beneath the bearing blocks. This allows ground-level or raised positioning of the rollers at any time
- Drive motors with planetary gears, enormous motor power with minimal power connection values,
- Test unit control: Manual / automatic operation, delayed automatic switch-on, slip switch-off, pointer stop, automatic restart, switch-off after driving out of the test bed, start-up monitoring and drive-off assistance
- Wear-free, electronic DMS measuring system with shear force transducer

Tractor specification for BPS-Twin-18.7:
enlarged roller wheelbase at 490 mm, both running rollers raised by 40 mm.
Testable wheel sizes from 13 – 48 inch
Attention! With cars with low ground clearance there is a risk of underside collision

Technical data for displays / control cabinet "BPS":
- Pointer display, housing dimension W x H x D 810 x 670 x 70 mm
- Brake force display, 172 ° 2 x 400 mm  mm
- Supply voltage pointer display 240/110 V, 50/60 Hz 16 A slow fuse
- Weight pointer display 10 kg
- Electrical/switch box, housing dimension W x H x D: 500 x 700 x 250 mm
with 2 test speeds (frequency converter)                      600 x 800 x 250 mm
- All housing painting basalt grey RAL 7012
- With frequency converter, customer-supplied all-current sensitive residual current circuit breaker with min. 0.3 A required

Technical data for roller set "BPS-Twin-18.7" (optional 11 KW motor):
- split roller set, hot-dip galvanised: Motors below the rollers
- Dimensions per roller set W x L x H: 1,410 x 1,145 x 545 mm
- Weight per roller set: approx. 460 kg
- Roller length: 1,150 mm
- Roller diameter: 268 mm
- Roller profile, welded: Friction value dry / wet 0.9/0.8
- Slip roller diameter: 80 mm
- Roller centre distance standard (with roller raising): 465 (max. 480) mm
- Test speed: Planetary gear with 2.6 km/h
- Noise emissions LWA: <70 DB (A)
- Traversable axle load: 18 t
Testable axle load at 50% braking: 14 (16) t
- Maximum braking power: 34 (42) kN
- Nominal power of drive motors: 2 x 9 (11) kW
- Supply voltage: 3 x 400 /50 V / Hz
- Feed line/fuse protection 5 x 6/32 (5 x 10/50) mm² / A
In general, with roller raising option 5 x 10/50
- Measuring system, shear force transducer with: integrated measuring amplifier DMS