BPS Twin-XT-13100 Tractor

OPTIONS

LED display “Dig-4” (RGB)

BPS Twin-XT-13100 Traktor

SVP410114 & SVZ410007

for cars, trucks and tractors, testable wheel size until 42" (split type)

Information request

"BPS Twin-XT " scope of supply
- 2 roller sets, hot-dip galvanised, for installation in an inspection pit, suspended installation, welded roller profile, 20 m pre-wiring to the control box
- TÜV-tested and approved for § 29 inspection

Description of "BPS- Twin-XT" roller set:
- 2 split roller sets, hot-dip galvanised, suspended installation with watertight, maintenance-free roller bearings
- Standard raised roller by 40 mm on the access side, exit side at ground level. The raised roller is implemented through shimming with compensation plates beneath the bearing blocks. This allows ground-level or raised positioning of the rollers at any time
- Drive motors with planetary gears, enormous motor power with minimal power connection values,
- Low-wear running rollers with welded profile surface (optionally grit-coated)
- Test unit control: Manual / automatic operation, delayed automatic switch-on, slip switch-off, pointer stop, automatic restart, switch-off after driving out of the test bed, start-up monitoring and drive-off assistance
- Wear-free, electronic DMS measuring system with shear force transducer

Tractor specification for BPS Twin-XT-13100/XT-16100:

enlarged roller wheelbase at 460 mm, both running rollers raised by 40 mm. Testable wheel sizes from 13 – 42 inch

Attention! With cars with low ground clearance there is a risk of underside collision

Technical data for displays / control cabinet "BPS":
- Pointer display, housing dimension W x H x D: 810 x 670 x 70 mm
- Brake force display, 172 °: 2 x 360 / 490 mm
- Supply voltage pointer display: 230/110 V, 50/60 Hz 16 A slow fuse
- Weight pointer display: 10 kg
- Electrical/switch box, housing dimension W x H x D: 500 x 700 x 250 mm
with 2 test speeds (frequency converter) 600 x 800 x 250 mm
- All housing painting basalt grey RAL 7012

- With frequency converter, customer-supplied all-current sensitive residual current circuit breaker with min. 0.3 A required

Technical data for roller set "BPS Twin-XT-13100”:
- split roller set, hot-dip galvanised: Motors below the rollers
- Dimensions per roller set W x L x H: 1,220 x 1,045 x 545 mm
- Weight per roller set: approx. 550 kg
- Roller length: 1,000 mm
- Roller diameter: 203 mm
- Slip roller diameter: 50 mm
- Roller centre distance: 420 mm
- Test speed: Spur gear motor with 2.6 km/h
- Noise emissions LWA: <70 DB (A)
- Traversable axle load: 13 (16) t
Testable axle load at 50% braking: 12,8 (14,4) t
- Maximum braking power: 32 (36) kN
- Nominal power of drive motors: 2 x 7.5 (9.0) kW
- Supply voltage: 3 x 400 /50 V / Hz
- Feed line/fuse protection: 5 x 6 / 32 mm² / A
- Measuring system, shear force transducer with: integrated measuring amplifier DMS

Enlarged roller wheelbase at 460 mm, both running rollers raised by 40 mm. Testable wheel sizes from 13 – 42 inch
Attention! With cars with low ground clearance there is a risk of underside collision!