+49 (0) 8636 / 60998 00
 
 

BPS Twin-XT-18115

SVP410135

for cars and trucks until 18 t axle load

Information request

BPS-Twin-XT" scope of supply
- 2 roller sets, hot-dip galvanised, for installation in an inspection pit, suspended installation, welded roller profile, 20
m pre-wiring to the electrical/control box
- Control box with motor protection switch, control electronics, operating elements and main switch lockable, prepared for
the connection of side slip and axle suspension tester, water jet-proof IP 65
- TÜV-tested and approved for § 29 inspection

Description of "BPS-Twin" roller set:
- 2 split roller sets, hot-dip galvanised, suspended installation with watertight, maintenance-free roller bearings
- Standard raised roller by 40 mm on the access side, exit side at ground level. The raised roller is implemented through
shimming with compensation plates beneath the bearing blocks. This allows ground-level or raised positioning of the rollers
at any time
- Drive motors with planetary gears, enormous motor power with minimal power connection values,
- Low-wear running rollers with welded profile surface (optionally grit-coated)
- Test unit control: Manual / automatic operation, delayed automatic switch-on, slip switch-off, pointer stop, automatic
restart, switch-off after driving out of the test bed, start-up monitoring and drive-off assistance
- Wear-free, electronic DMS measuring system with shear force transducer

Technical data for displays / control cabinet "BPS":
- Pointer display, housing dimension W x H x D: 810 x 670 x 70 mm
- Brake force display, 172 ° :2 x 360/490 mm Ø mm
- Supply voltage pointer display: 230/110 V, 50/60 Hz 16 A slow fuse
- Weight pointer display: 10 kg
- Electrical/switch box, housing dimension W x H x D with 2 test speeds (frequency converter):
500 x 700 x 250 / 600 x 800 x 250 mm
- All housing painting: basalt grey RAL 7012
- With frequency converter, customer-supplied all-current sensitive residual current circuit breaker with min.
0.3 A required

Technical data for roller set "BPS Twin-XT-18115":
- split roller set, hot-dip galvanised: Motors below the rollers
- Dimensions per roller set W x L x H: 1,410 x 1,145 x 545 mm
- Weight per roller set: approx. 900 kg
- Roller length: 1,150 mm
- Roller diameter: 265 mm
- Slip roller diameter: 80 mm
- Roller centre distance standard (with roller raising): 465 (max. 490) mm
- Test speed: Planetary gear with 2.6 km/h
- Noise emissions LWA: <70 DB (A)
- Traversable axle load: 18 t
Testable axle load at 50% braking: 14 t
- Maximum braking power: 34 kN
- Nominal power of drive motors: 2 x 9 kW
- Supply voltage: 3 x 400 /50 V / Hz
- Feed line/fuse protection In general: 5x10/50 mm²/A
- Measuring system, shear force transducer with: integrated measuring amplifier DMS